3D site planning is a way to test a development concept against the conditions of a particular location. It combines a spatial baseline, editable layouts and measurable indicators. The aim is to identify useful options and unresolved constraints before detailed design. A 3D study does not guarantee permission or a faster approval.

1. Define the decision and site boundary
State what the study must establish: whether to investigate a site further, which housing mix to test or which layout deserves detailed work. Confirm the study boundary and distinguish owned land from connections that depend on others. Record the assumptions that could change the decision.
2. Assemble and check the baseline
Start with parcel geometry, terrain, existing buildings, access and available planning information. Add relevant environmental and infrastructure layers. Record the source, date, coordinate system, licence and limitations. A regional map can identify a concern without resolving its extent on the site.
Use the site evaluation guide to organise the evidence. Keep missing information in an investigation register rather than treating an absent layer as proof that no constraint exists.
3. Translate constraints into a testable model
Separate fixed conditions from assumptions you intend to vary. Map access points, setbacks and provisional exclusion areas where supported by the evidence. Record how planning controls have been interpreted. A massing envelope is a working interpretation, not a formal determination of development rights.
4. Build contrasting alternatives
Create a small set of options that test a real choice, such as compact blocks versus a more open arrangement. Include streets, parking, public space and servicing assumptions alongside buildings. Keep all options on the same site boundary and use consistent area definitions.
5. Measure the trade-offs
Compare housing, floor area, footprint, density, access, parking and connected open space. Add financial assumptions where the study requires them. Label calculations as estimates and distinguish direct spatial measures from outputs supplied by specialist models.
For an illustrative one-hectare site, a 2,500 m² building footprint covers 25% of the site. That simple ratio does not tell you the permitted floor area, number of homes or whether a scheme is feasible. See the floor area ratio guide for the distinctions.
6. Review, revise and hand over
Use matching viewpoints and a consistent indicator table to review options. List the selected direction, rejected alternatives and the reasons for the decision. Assign unresolved questions to the appropriate owner. Engineering, financial, environmental and planning reviews should follow the project’s actual requirements.
Using 3D Cityplanner
The 3D Cityplanner features describes tools for spatial context, road and building generation, scenario comparison, programme quantities and shared review. Confirm the relevant data and modules using your own site. Keep detailed design and authoritative assessments in the appropriate specialist workflow.
Frequently asked questions
How detailed should the first model be?
Detailed enough to answer the decision question and expose important constraints. Add detail when it can change the comparison.
Can the model establish that a site is developable?
It can support an early feasibility screen. Development rights, service capacity and formal approvals require separate verification.
